500 grams Distilled Water, hot
28.5 g BTMS-50
5 g Panthenol
28 g Nettle Extract
6 g Oat Extract
6 g Hemp Seed Oil
preservative of your choice
Disolve Panthenol into a few tablespoons of distilled water and set aside. Heat the remainder of the water in the microwave.
In a double boiler, melt the BTMS-50 and Hemp Seed Oil. Once clear and completely melted, whisk slowly into the heated distilled water.
Let the mixture cool for a few minutes and then add the remaining ingredients. (I used Optiphen-ND for my preservative at 1%)
pH test, you want to have your conditioner to have a pH of 5-6.
When slightly warm still, pour into containers, allow to cool with cap off for several hours or over night before sealing.
I ran out of hair conditioner while moving so I made this up quick.
I went heavy on the extracts and there is almost no oil in it because I co-wash. If you use this small amount of oil, melting the BTMS-50 in a double boiler can be a bit of a struggle, make sure the Distilled Water is also hot and whisk as you mix them, I recommend checking the instructions and temperature listings on the ingredient packages so you know when to add your extracts. I scented it with Pikake flower and tart apple as my last ingredients along with the preservative.
28.3 grams BTMS -50
5.66 grams Argan Oil
411 grams Distilled Water
5.66 grams Pantenol
28.3 grams Aloe Extract
28.3 grams Avocado Extract
28.3 grams Nettle Extract
28.3 grams Liquid Silk
5.66 grams Hydrolyzed Oats
5.66 milliliters Optiphen ND
I have several recipes I want to try so I worked out a change of recipe each season depending which ingredients fit the season best.
My summer conditioner was argan and nettle, I’m trading those for carrot, oat and avocado.
411 grams Distilled Water
28 grams BTMS-50
6 grams Panthenol
30 grams Oat Extract
28 grams Carrot Extract
28 grams Liquid Silk
6 grams Hydrolyzed Oats
6 grams Avocado Oil
1% Optiphen ND
In a double boiler heat the BTMS-50 and avocado oil until it is clear and mixed well.
In a microwave heat the distilled water past the melting point of your BTMS-50 but not to boiling point.
With a whisk add the Pantenol into the water until disolved, then add the BTMS-50 into the water and whisk constantly for about 5 minutes. While mixing add the remaining ingredients.
While still heated pour into bottles and set aside to cool for at least 8 hours before putting the cap on.
Here we go, I’ve been reading up on this for a while a few things to get familiar with before you start should be cationic quaternary compound’s and PH.
I feel like I am ready to try making a batch of hair conditioner. I researched ingredients for a while then built some basic recipes around what I have on hand. Sketched out several recipes for General Use(Argan & Nettle), Moisturizing (Coconut & Avocado) , Dandruff(Tea Tree, Avocado & Nettle), Winter Hair (Carrot & Oat), Invigorating(Jojoba, Rosemary & Peppermint).
My first attempt is as follows, this was my ‘general use’ idea.
90.5% Distilled Water
3% Nettle Extract
1% Argan Oil
1% Fragrance (I used green apple)
It was a little on the thin side, and very appley! If I were remaking this recipe right now I would make the following adjustments 0.5% fragrance and 4% BTMS-50.